CM5-LTS accessories

  • Genuine Honeywell MAP for CM5-LTS QUICK VIEW Genuine Honeywell MAP for CM5-LTS $99.00 USD

    Genuine Honeywell MAP for CM5-LTS

    $99.00 USD

    Genuine Honeywell Absolute Pressure Sensor Kit Option Includes: 50PSI or 100PSI Absolute Pressure Brass-Body Sensor with a 1/8" NPT Male Thread Brass barbed hose fitting for 3/16" (4.76mm) ID Vacuum Hose...
    View full product details →
  • Fused Power/Ground Kit for CM5-LTS QUICK VIEW Fused Power/Ground Kit for CM5-LTS $29.00 USD

    Fused Power/Ground Kit for CM5-LTS

    $29.00 USD

    Kit Option Includes: Genuine Littelfuse automotive JCASE fuse holder with 10AWG (5.0mm^2) wires Genuine Littelfuse automotive 40A fuse (low profile) Genuine TE Connectivity PIDG Ring Terminals (2x M6, 1x M5 and 1x...
    View full product details →
  • Auxiliary Pump Harness for CM5-LTS QUICK VIEW Auxiliary Pump Harness for CM5-LTS $29.00 USD

    Auxiliary Pump Harness for CM5-LTS

    $29.00 USD

    Supplied with 2 Blue Molex/TE PermaSeal/DuraSeal 16-14AWG wire splices (not shown) Length: 14ft (425cm)Wire: 14AWG Automotive SXL Wire
    View full product details →
  • I/O Expansion Module for CM5-LTS QUICK VIEW I/O Expansion Module for CM5-LTS $99.00 USD

    I/O Expansion Module for CM5-LTS

    $99.00 USD

    This module plugs into the CM5-LTS wiring and breaks out the following optional signals: CANBus Dash-Mounted LCD Display or Gauge Analog A and B 0-5V Inputs Torqbyte A and B...
    View full product details →

Connect With Us

Latest Posts

  • GPO - Generic Boost Cut Strategy

    CM5 and CM5-LT are able implement 3 water methanol safety approaches and take action to cut boost whenever system trouble is detected in order to save the engine from overboost. The 3 safety approaches are: Approach 1: Activate one of the two... Read more →

  • GPO - Relay Control

    CM5 and CM5-LT are equipped with two, pull-to-ground, General Purpose Outputs, GPO1 and GPO2 that can each be configured to switch ON or OFF either ABOVE or BELOW some setpoint. This setpoint is a combination of engine RPM and either... Read more →

  • GPO - Auxiliary Injector Control

    CM5 and CM5-LT are equipped with two, pull-to-ground, General Purpose Outputs, GPO1 and GPO2 that can each be controlled with a separate 3D 16x16 cell duty table. In this mode the outputs are pulsed at a fixed frequency of 30Hz. One possible use... Read more →