CAN-Enabled I/O Expansion Module for gaugeART Gauge

Torqbyte Inc.

$165.00 USD 

Share:

Note: Although it looks the same, the I/O Expansion Module in this kit is not the same as the Standard CM5-LTS I/O Expansion Module (the boards inside are different).

The unterminated Orange wire controls the gauge's dimming function. When connected to +12V the gauge dims. When it's left unconnected the gauge operates at the maximum brightness.

Important: The Terminator Jumper on the back of the gauge must be installed.

gaugeART Termination Jumper

Length: 5ft (1.5m)
Wire: 20AWG Automotive TXL Wire

Connect With Us

Latest Posts

  • Determining TorqTune2 MAP Sensor Values

    CM5-LTS is able to obtain boost readings from any analog 0-5V Manifold Absolute Pressure (MAP) sensor, but it requires the user to provide a few senor-specific MAP Calibration parameters (Slope, Intercept, Atmosphere and Deadband) in order to accurately convert the... Read more →

  • Using the Factory BMW T/MAP Sensors with the CM5-LTS

    In most BMW applications with a CM5-LTS WMI controller, it is preferred to obtain boost readings by "teeing" into the factory TMAP sensor wiring. Below is the information on how to do this for several popular BMW TMAPs we have... Read more →

  • GPO - Generic Boost Cut Strategy

    CM5 and CM5-LT are able implement 3 water methanol safety approaches and take action to cut boost whenever system trouble is detected in order to save the engine from overboost. The 3 safety approaches are: Approach 1: Activate one of the two... Read more →