PM5 US-Spec RS3 DAZA Plug-n-Play Kit

Torqbyte Inc.

$199.00 USD 

Share:

Plug-n-Play Wiring Kit for US-Spec TTRS/RS3 DAZA cars with:

FPCM: 4M0 906 093
Fuel Sender Top Hat (Blue): 8V0 919 087
Fuel Pump Connector: 4M0 973 724

Includes a sealed connector housing that accepts female terminals that need to be removed from the factory connector housing that normally connects to the factory fuel pump controller which is removed when the PM5 is installed. Also included is a fully terminated pump wire harness with 10AWG (5.0mm^2) TXL wires for maximum power transfer that mates directly with the factory fuel sender top hat.

Note: Contact Removal Tool (sold separately) is highly recommended to ensure proper installation

Connect With Us

Latest Posts

  • Updating CM5-LTS Firmware for Use With TorqTune2

    This guide will explain how to update the CM5-LTS firmware so the unit can be used with the latest TorqTune2 software. Note: This firmware update can only be performed on current CM5-LTS units with rectangular LEDs. It is not compatible with... Read more →

  • Determining TorqTune2 MAP Sensor Values

    CM5-LTS is able to obtain boost readings from any analog 0-5V Manifold Absolute Pressure (MAP) sensor, but it requires the user to provide a few senor-specific MAP Calibration parameters (Slope, Intercept, Atmosphere and Deadband) in order to accurately convert the... Read more →

  • Using the Factory BMW T/MAP Sensors with the CM5-LTS

    In most BMW applications with a CM5-LTS WMI controller, it is preferred to obtain boost readings by "teeing" into the factory TMAP sensor wiring. Below is the information on how to do this for several popular BMW TMAPs we have... Read more →