PM5 VAG CANBus Gateway PnP Adapter - Standard Length

Torqbyte Inc.

$155.00 USD 


Plug-n-Play solution for obtaining RPM and Boost directly from the vehicle's CANBus Gateway located under the dash directly above the steering wheel universal joint.

Compatible with 2016+ Audi A3/S3/RS3 and Mk7 Golf GTI, Golf R models.

Boost readings can be used to progressively raise or lower the pump voltage via the optional integrated voltage booster, which allows for obtaining the maximum pump output at peak engine loading without permanently running the pump at a high voltage.

Both Boost and RPM can be logged using our free TorqBLPM software and related to other logs captured with other tuning tools. 

Standard length is ideal for setups where the controller and the CAN gateway are installed at the same end of the vehicle (e.g. both under the dash or both in the trunk)

Length: 5ft (1.5m)
Wire: 20AWG Automotive TXL Wire

Connect With Us

Latest Posts

  • Updating CM5-LTS Firmware for Use With TorqTune2

    This guide will explain how to update the CM5-LTS firmware so the unit can be used with the latest TorqTune2 software. Note: This firmware update can only be performed on current CM5-LTS units with rectangular LEDs. It is not compatible with... Read more →

  • Determining TorqTune2 MAP Sensor Values

    CM5-LTS is able to obtain boost readings from any analog 0-5V Manifold Absolute Pressure (MAP) sensor, but it requires the user to provide a few senor-specific MAP Calibration parameters (Slope, Intercept, Atmosphere and Deadband) in order to accurately convert the... Read more →

  • Using the Factory BMW T/MAP Sensors with the CM5-LTS

    In most BMW applications with a CM5-LTS WMI controller, it is preferred to obtain boost readings by "teeing" into the factory TMAP sensor wiring. Below is the information on how to do this for several popular BMW TMAPs we have... Read more →