BMW OBD-II Breakout Adapter for CM5-LT

Torqbyte Inc.

$45.00 USD 

Share:
  • Breaks out RPM, IGNITION and GROUND connections from OBD-II Connector in BMW vehicles to the CM5-LT Water Methanol Controller.
  • Plug-n-Play operation eliminates the need to disturb the factory wiring.
  • Male-Female construction allows for unobstructed use of the OBD-II port for coding, tuning and diagnostics.

CM5-LT is one of the most popular Water Methanol Injection (WMI) controllers for gasoline and diesel powered BMW vehicles.

Its powerful engine load approximation algorithm makes it the controller of choice for savvy BMW tuners tired of primitive "progressssive" controllers or other inferior solutions that add WMI control functionality as just a value-added afterthought.

CM5-LT integration in BMW vehciles is extremely easy because BMW brings out all the necessary signals to the vehicle's OBD-II port - including a clean, square wave RPM signal !!!

All that is needed in any MY2000 or newer BMW chassis is to access the following connections:

OBD-II Pin 1 -> Orange (IGN) -> CM5-LT Pin 9
OBD-II Pin 5 -> Black (GND) -> CM5-LT Pin 4
OBD-II Pin 9 -> Yellow (RPM) -> CM5-LT Pin 10

BMW OBD-II Connections

 

Obviously it's undesirable to modify the vehicle's OBD-II connector or insert pins into the connector that can render it unusable for other port tools or cables.

This Torqbyte OBD-II breakout adapter makes CM5-LT installation in BMW cars quick and easy. The wires are color-coded to the CM5-LT Input/Output harness and the supplied sealed splices ensure a secure and durable connection.

The adapter is designed as a male-female passthrough. With is male end plugged into the vehicle's OBD-II port its female end can accept usual OBD-II port hardware.
 

Installation Information

Connect With Us

Latest Posts

  • GPO - Generic Boost Cut Strategy

    CM5 and CM5-LT are able implement 3 water methanol safety approaches and take action to cut boost whenever system trouble is detected in order to save the engine from overboost. The 3 safety approaches are: Approach 1: Activate one of the two... Read more →

  • GPO - Relay Control

    CM5 and CM5-LT are equipped with two, pull-to-ground, General Purpose Outputs, GPO1 and GPO2 that can each be configured to switch ON or OFF either ABOVE or BELOW some setpoint. This setpoint is a combination of engine RPM and either... Read more →

  • GPO - Auxiliary Injector Control

    CM5 and CM5-LT are equipped with two, pull-to-ground, General Purpose Outputs, GPO1 and GPO2 that can each be controlled with a separate 3D 16x16 cell duty table. In this mode the outputs are pulsed at a fixed frequency of 30Hz. One possible use... Read more →